POLE SHAFT - Pole shaft is electro-welded ASTM-A500 Grade C steel tubing with a minimum yield strength of 50,000 psi. On Tenon Mount steel poles, tenon is 2-3/8” O.D. high-strength pipe. Tenon is 4-3/4” in length. Straight poles are 4”, 5”, and 6” square.
HAND-HOLE - Standard hand-hole location is 12” above pole base. Poles 22’ and above have a 3” x 6” reinforced hand-hole. Shorter poles have a 2” x 4” non-reinforced hand-hole.
BASE - Pole base is ASTM-A36 hot-rolled steel plate with a minimum yield strength of 36,000 psi. Two-piece square base cover is optional.
ANCHOR BOLTS - Poles are furnished with anchor bolts featuring zinc-plated double nuts and washers. Galvanized anchor bolts are optional. Anchor bolts conform to ASTM F 1554-07a Grade 55 with a minimum yield strength of 55,000 psi.
GROUND LUG - Ground lug is standard.
DUPLEX RECEPTACLE - Weatherproof duplex receptacle is optional.
GROUND FAULT CIRCUIT INTERRUPTER - Ground fault circuit interrupter is optional.
FINISHES - Each pole is finished with DuraGrip®, LSI’s baked-on polyester-powder finishing process which electrostatically applies and fuses a polyester powder to the pole. Provides an extremely smooth and uniform finish to withstand extreme weather changes without cracking or peeling, and features a five-year limited warranty. Optional DuraGrip® Plus features the added protection of a 3.0 to 5.0 mil thickness of polyesterpowder finish plus an inner coating, as well as a seven-year limited warranty
DETERMINING THE LUMINAIRE/POLE COMBINATION FOR YOUR APPLICATION:
• Select luminaire from luminaire ordering information
• Select bracket configuration if required
• Determine EPA value from luminaire/bracket EPA chart
• Select pole height
• Select MPH to match wind speed in the application area (See windspeed map).
• Confirm pole EPA equal to or exceeding value from note above
• Consult factory for special wind load requirements and banner brackets
|Manufacturer Warranty||5 Year|
|Lead Time||Build Item 2-3 Weeks|